More details at valarievsschmitz(at)delboys.com . 2006 Dodge Ram 2500 4x4 SLT. 34 - original miles on the truck. Less then 100 miles on a fresh built motor transmission transfer case injectors and turbo charger. Very good condition. Original owner. Truck has never been in accident. It has AC power windows heated and power mirrors 6 disc changer satellite radio manual t-case lever power locks etc Truck is a 4x4 that has been dropped 4 inches in the rear and 2 up front. Engine Number 4 cylinder burned a piston so the motor was taken to Mountain High Performance in Arvada Colorado. Mountain high is a respected shop and Bill the owner has built Cummins motors that have powered trucks to 9 second quarter mile passes. The cylinder head was gone through and all cracked were repaired. The head was given a big valve conversion to increase flow. New seats were also installed with 1.340 oversized valves. All guides were repaired as needed and the head was decked to .008 . Some light porting polishing was also done. The block was boiled and cleaned and the burned cylinder was sleeved and everything was bored to .040 over. Each cylinder was honed to fit each piston and they were numbered in order so they were all fitted to their respective cylinders. All bearings were also replaced. The engine was balanced and the crank cam drive gears push rods connecting rods pistons rings main bearings oil pump and sleeve were all cryogenically treated to increase the harness of the material. Freeze plugs were also threaded to prevent them from popping. ARP 425 head studs and main studs were used. Cam shaft is a Hamilton 188 cam with their valve springs and HD push rods. The connecting rods used were new 12 valve rods that were shot peened and cryo treated. The machine work alone ran a discounted cost of 8 608 which would have easily been over 10 000 had I not worked in the same industry and dealt with the shop on a day to day basis. Aftermarket parts ATS Stage VI transmisison. Billet shafts flywheel co-pilot five star converter and deep pan. Trans was gone through less then 100 miles ago at ATS. 8 580 ATS Aurora 5000 Turbo Kit 2 087.27 ATS Twin CP3 kit 2 350 ATS Exhaust Manifold 495 Hamilton 188 cam 699 Hamilton Push Rods 275 Hamilton Valve Springs 399 ARP 425 Head Studs 430 FASS 220GPH Titanium fuel system 860 Dynomite 220HP Injectors 4 000 Beans Diesel Fuel Sump 149.95 Starlite Diesel Autocal with Custom Tuning 795.00 Fuel Rail Cap 50 Autometer C2 gauges -Boost -Pyro -Drive Pressure -Trans Temp -Drive Pressure -Fuel Pressure All in a overhead pod and a pillar pod Total 842 Nitrous kit with custom painted bottle and billet bracket (never used on this motor) 600 Cal Trac Traction Bars 419.00 H2 Wheels 400 Custom stack with FTE resonator 560 Total parts 23 941.54 Machine Work 8 608 (heavily discounted) Labor was all done myself but would cost someone somewhere around 4000 for all of this. What it would cost you to build this truck not including the truck approximately 36 549.54 and that is with heavily discounted machine work. This truck by itself with only 34K miles would fetch somewhere around 30 000 is my guess. That is 66 549 if you had to go out and do all this yourself This is a heck of a deal. Truck has not been dynoed on it s old setup with stock head and cam it made 730 rear wheel horsepower on fuel and 918HP on nitrous on bulldog tuning. The best previous time it has not been ran since was a 11.2(at)124mph. This is a easy 10 second truck now. As I said I am the original owner of this truck. It was purchased while I was a senior in high school and I love it. Sadly I am relocating to California and need to afford some expensive real estate. Truck really needs nothing but a new owner. Truck does not have a bumper in the pictures it will have a painted to match roll pan on by the time the auction ends done by a reputable shop. Really the only issue with the truck is a few small rock chips along the very lower rockers from a dirt road and a very slight scratch on the front right fender. Interior isn t perfect but it looks pretty darn good for 10 years old. For the past three years I have worked at one of the largest diesel performance shops in the area this truck is done right
Category: Trucks & Vans
There are a lot of advertisers on Advertigo. We cannot check them one by one.
You work hard for your money and you want a company you can rely on when you are buying or selling things. That’s why we want to help you protect yourself from fraud. In this section, you’ll find informative tips and other useful material to stay informed and help reduce your chances of falling victim to scammers.
Please understand that Advertigo.net is a free service to help buyers and sellers (and etc.) find one another. Advertigo.net is not involved in any transactions and can not police the actions of our many users.
