How to use baby UV disinfection steriliser and precautions (New York, NY)

How to use baby UV disinfection steriliser and precautions

How much water to add to Baby UV disinfection steriliserWhen using baby UV disinfection steriliser to sterilize feeding bottles the amount of water added should be determined according to the number of feeding bottles to be sterilized. In general all bottles to be sterilized should be immersed in water. Nartisan will introduce the steps of cleaning and disinfection. Pour about 100ml of water into the electric heating plate put it into the milk bottle storage compartment then insert the cleaned milk bottle upside down on the milk bottle storage compartment cover the pot and press the start button. In about 15 minutes the bottle is sterilized.Baby UV disinfection steriliser water change requirementsWhen sterilizing the bottle be sure to replace the water in the sterilizer do not use it repeatedly otherwise it will cause secondary pollution. The water in the baby UV disinfection steriliser needs to be replaced every time it is sterilized so that bacteria can be completely killed. The above introduces the reasons for baby UV disinfection steriliser water change requirements.How to use baby UV disinfection steriliserThe correct step is to read the instruction manual of the baby UV disinfection steriliser first and follow the instructions in the instruction manual. Before use use the baby bottle cleaner to clean the baby bottle first then put clean water in the baby bottle tighten the bottle cap and put it in the baby. In the UV disinfection steriliser it is enough to set the temperature and time of disinfection. When using the baby UV disinfection steriliser for the first time it is necessary to sterilize the baby UV disinfection steriliser first and do not put it into a feeding bottle. It can be used normally only after it has been fully sterilized. The above is how to use baby UV disinfection steriliser. Precautions for use of baby UV disinfection sterilizerThe bottle should be sterilized after cleaningWhether you use a steam or ultraviolet disinfection steriliser you must wash the bottle and nipple thoroughly before putting it into sterilizer. If the bottle is not thoroughly washed and there are still milk stains in the bottle the purpose of disinfection and sterilization cannot be achieved.Avoid dampness inside the disease steriliserAlthough some disease sterilisers boast a drying function when you are using them it is recommended to shake off the moisture in the bottle or nipple first so as not to reduce the service life of the disease steriliser.Placing flat for accurate sterilizationWhen putting baby bottles and pacifiers into the disinfection steriliser please place them as flat as possible and do not pile them up randomly to avoid dead corners of disinfection. The above is the precautions for use of baby UV disinfection steriliser.